simple-metal-bed
Simple print bed 2

Printrbot Simple Metal Print Bed

$20.00

Category: .

Product Description

A perfectly level metal print bed with for your Printrbot Simple.  No hardware included (since you already have the necessary hardware that came with your Simple).  If your wood bed has warped, this is your answer!

  • 6061 Aluminum (harder than your run-of-the-mill aluminum… 6061 is commonly used in aircraft)
  • tumbled finish gives it a soft, matte look (not shiny)
  • 4 tapped M3 holes to mount the heated bed that you may eventually buy :)  - the heater will bolt underneath
  • 4 mounting holes in the 4 corners that are a match for your current Simple

TIP: don’t tighten the screws (with the springs around them) down too low, or it will catch on the wood when it goes all the way to one side or the other.

If you’re doing a hack and using a heated bed, you may also wish to purchase a thermistor with cable.

Additional Information

Weight .5 lbs
Dimensions 7 x 5 x 1 in